OCD with Pedal Power 4x4

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
hamabdullah
Posts: 5
Joined: Sat Jan 17, 2015 1:58 am

OCD with Pedal Power 4x4

Post by hamabdullah » Mon Dec 04, 2017 12:44 am

Hi Labgods,

need help to place OCD on the 4x4 as I've been getting mix answers reading thru the forum.
Where can I place the OCD with the 4x4? Can I put it on the 9v or the 9v high 400ma area? please help

JohnClark
Posts: 7127
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: OCD with Pedal Power 4x4

Post by JohnClark » Mon Dec 04, 2017 4:35 pm

The OCD will accept 9-18V DC so it can be powered from any output on a Pedal Power 4x4, 9V or 12V. If you wanted to run it specifically at 18V you will need a Voltage Doubler Adapter connected to any two 9V Outputs.

For the current rating, a pedal will only draw the amount of current it needs to operate. The OCD somewhere around 10mA so it would be equally fine from either the 100mA or 400mA outputs.

I hope that helps!

Post Reply