It is currently Wed Apr 26, 2017 2:51 am

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Hex Amp Channel Selection
PostPosted: Mon Mar 20, 2017 11:34 am 
Offline

Joined: Mon Mar 20, 2017 11:09 am
Posts: 1
Q1: The HEX is stated to use Isolated loop 1 for amp channel select. I have a MESA Transatlantic TA-15 that uses a foot switch to change amp channels. How do I wire Isolated Loop 1 to do this?

Q2 (in case Q1 is not fesible): The HEX is stated to use Isolated loop 1 as an A/B select.How do I wire Isolated Loop 1 to do this?

IT would be great to have documentation for this in the manual or somplace


Top
 Profile  
 
 Post subject: Re: Hex Amp Channel Selection
PostPosted: Tue Mar 21, 2017 10:24 am 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 6377
Location: The Lab
No problemo for either use...

1. Connect only the Out of Loop 1 to the Footswitch jack on the TA-15 using a standard instrument cable to have HEX control the amp Channels.

2. What do you want to A/B? If you will be switching between two amps you would route the audio signal to the In of Loop 1, the Out of Loop 1 would go to amp "A" and the Send of Loop 1 would go to amp "B".

_________________
Image
Voodoo Lab ®
Magician/Tech


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: