|
It is currently Thu Apr 26, 2018 2:18 am
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
Boneguitar
|
Post subject: Px plus general set up before programming Posted: Thu Dec 28, 2017 4:35 am |
|
Joined: Thu Dec 28, 2017 4:10 am Posts: 1
|
Good morning voodoo lab forum,
I need advice or help. Just purchased the px plus dingbat board
I want to make sure I am setting this up correctly
Here is the signal path
Guitar to pedals( always in use pedals)
Out of the last pedal into the input on the px-8
I have 5 pedals in the loop right now so loops 1 through 5 are in use
To each of these loops I am using the send to one pedal and output of the same pedal back into that specific loop
Then I am using the main output back to the amplifier
Am I doing something wrong I am not having success at this point...
Cheers and thank you for any thoughts or recommendations!
Boneguitar
|
|
Top |
|
 |
JohnClark
|
Post subject: Re: Px plus general set up before programming Posted: Wed Jan 03, 2018 11:04 am |
|
Joined: Tue May 05, 2009 2:33 pm Posts: 6966 Location: The Lab
|
Your description of the setup seems fine. What problem are you having? No signal at all? Dry signal but no effects?
|
|
Top |
|
 |
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: Bing [Bot] and 6 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|