Px plus general set up before programming

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
Posts: 1
Joined: Thu Dec 28, 2017 4:10 am

Px plus general set up before programming

Post by Boneguitar » Thu Dec 28, 2017 4:35 am

Good morning voodoo lab forum,

I need advice or help. Just purchased the px plus dingbat board

I want to make sure I am setting this up correctly

Here is the signal path

Guitar to pedals( always in use pedals)

Out of the last pedal into the input on the px-8

I have 5 pedals in the loop right now so loops 1 through 5 are in use

To each of these loops I am using the send to one pedal and output of the same pedal back into that specific loop

Then I am using the main output back to the amplifier

Am I doing something wrong I am not having success at this point...

Cheers and thank you for any thoughts or recommendations!


Posts: 7164
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Px plus general set up before programming

Post by JohnClark » Wed Jan 03, 2018 11:04 am

Your description of the setup seems fine. What problem are you having? No signal at all? Dry signal but no effects?

Post Reply