Voodoo Lab

Hi there,
I've just got myself a DBX1074 for my rig and would like some ideas on how to set it up. At the moment my signal is as follows:
Guitar > GCX IN > GCX OUT > NS-1 > y cable to Triaxis and Radial ABY ( for isolation and phase 180) > Dual Rectifier

Dual Rectifier > 1/2 of left side 4x12.
Dual Rectifier Slave > Stilleto Deuce Return > 1/2 of right side 4x12.

Triaxis A out > GCX 3 > Mesa EQ Pedal > GCX 3 > GCX 1-2 > GMajor 2 L IN > GMajor L&R OUT > GCX 1-2 > 2:90 A&B > 1/2 of each side 4x12.

I am using the noise suppression on the NS-1 to get rid of guitar noise and the gate/suppressor on the GMajor for crunch noise. Would like to use the DBX1074 for clean and crunch. Was thinking of using 2 channels on the GCX that cut in on clean and crunch so I have 2 different settings. Should I still use the NS-1 in front or another channel on the 1074? Should I use the 1074 after the GMajor in stereo for crunch, turned off for clean? Should I use it after the GCX but before the y cable with the clean setting for clean and have it on when distorted to? Should I have a different setting for clean and crunch after the GCX before the Y cable?

Any preferences or suggestions would be highly welcome.

Cheers

Hi there all, this is my first post so I thought I'd see if I can get some suggestions on a little rack setup.

I have a couple of bits in my rack as follows

Triaxis
Gmajor 2
Mini Amp Gizmo
GCX

All controlled via GCPro

I don't have a Power Amp, Mesa 2:90 or 2:100 would be awesome, so was thinking of using both my Dual Rectifier's and Stiletto Deuce's power side in a stereo setup as I have 2 cabs and using the Triaxis and Dual Rectifier(and maybe even the Stiletto) as preamps. I have the Mini Amp Gizmo and cable to switch the Rectifier via MIDI. I have a heap of other FX pedals/multi FX aswell. Was thinking I'd put my NS-2 in front to.

Cheers Brett